INSTALLATION INSTRUCTIONS
10STEP 15Adjusting Monitor TiltSINGLE AND DUAL QUICKSTAND• Hold the top and bottom of your monitor and manually adjust the monitor tilt until the d
www.humanscale.comHSRI0514Customer Service: N America +1 800 400 0625 / International +353 (0)1 858 0910
PARTS REQUIREDSingle QuickStand PartsA (1) QuickStand UnitB (1) Base PlateC (1) PlatformD (1) Palm SupportE (1) VESA PlateF (6) M8 x 18 mm Flat
3STEP 1Remove Shipping PlateTools: 6 mm Hex Key• Lay the QuickStand unit on the work surface facing up and unscrew the (2) M8 x 10 mm Cap Head Machi
4STEP 4Measure Work Surface Depth IMPORTANT: Please check the depth of your work surface - If you are installing a QuickStand with a Large Platform
5STEP 6Attaching QuickStand to the Work SurfaceIMPORTANT: Your QuickStand unit is heavy. If needed, please have assistance when lifting.• Carefull
6STEP 8Attaching Crossbar for Dual Monitors Tools: 3 mm Hex Key 4 mm Hex Key• Attach Dual Monitor Crossbar to QuickStand unit using the hardware ki
7ST EP 11Attaching USB DevicesTools: Flat-Head Screwdriver• Using a Flat-Head Screwdriver if needed, remove cable cover by tilting out from the bott
8STEP 12Removing Brace Box • Remove tape and lift out box. (fig. Q)STEP 13Adjusting Weight Capacity WARNING: Do not use a Power Drill to adjust the te
9STEP 14Adjusting Monitor HeightSINGLE QUICKSTAND• Hold each side of your monitor and manually raise or lower until it is in the correct position (fi
Commenti su questo manuale